DS CEN/TS 1852-2:2009

Plastics piping systems for non-pressure underground drainage and sewerage - Polypropylene (PP) - Part 2: Guidance for the assessment of conformity

Scope

1.1 General
This draft Technical Specification gives guidance for the assessment of conformity to be included in the
manufacturer's quality plan as part of the quality system.
This draft Technical Specification includes:
a) requirements for materials, components, joints and assemblies given in EN 1852-1;
b) requirements for the manufacturer's quality system;
NOTE 1 It is recommended that the quality system conforms to EN ISO 9001:1994 [1].
c) definitions and procedures to be applied if third party certification is involved.
NOTE 2 If third party certification is involved, it is recommended that the certification body is accredited to
EN 45011:1998 [2] or EN 45012:1998 [3], as applicable.
1.2 Applicability
This draft Technical Specification is applicable to piping systems made of polypropylene (PP) intended to be
used for:
a) non-pressure underground drainage and sewerage outside the building structure (application area code
"U"), reflected in the marking of products by "U", and
b) for non-pressure underground drainage and sewerage for both buried in the ground within the building
structure (application area code "D") and outside the building structure (application area code "U"),
reflected in the marking of products by "UD".