Publikuar
The present document covers the minimum characteristics considered necessary in order to avoid harmful interference
and to make acceptable use of the available frequencies.
The present document applies to equipment with integral antennas, used in angle modulation systems in the land mobile
service, operating on radio frequencies between 30 MHz and 1 000 MHz, with channel separations of 12,5 kHz, 20 kHz
and 25 kHz, and is intended primarily for analogue speech.
In the present document different requirements are given for the different radio frequency bands, channel separations,
environmental conditions and types of equipment, where appropriate.
The present document is complementary to ETSI EN 300 086 [i.6], which covers radio equipment with an internal or
external RF connector, for use in the land mobile service.
The present document may apply to PMR446 equipment as defined in [i.7]. Note that PMR446 equipment has a
requirement to incorporate a receiver and may have requirements for 180 s maximum transmission time and VOX.
Table 1: Radiocommunications service frequency bands
Radiocommunications service frequency bands
Transmit 30 MHz to 1 000 MHz
Receive 30 MHz to 1 000 MHz
The present document contains requirements to demonstrate that "... Radio equipment shall be so constructed that it both
effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference" and that "....radio
equipment supports certain features ensuring access to emergency services" [i.8].
In addition to the present document, other ENs that specify technical requirements in respect of essential requirements
under other parts of article 3 of the Radio Equipment Directive [i.8] may apply to equipment within the scope of the
present document.
PUBLISHED
SSH EN 300 296 V2.1.1:2016
60.60
Standard published
27 korr 2016